Inferno LCD1510 Instrucciones De Uso página 9

TROUBLE SHOOTING
LCD DISPLAY
ERROR
+
OVER HEAT
ERROR
+
NO CONNECTION
ERROR
+
BATTERY VOLTAGE
MISMATCH
ERROR
+
BAD BATTERY
ERROR
+
REVERSE POLARITY
ERROR
+
OVERLOAD
WARRANTY
1) This product is warranted to the original purchaser for a period of two (2) years from
the original shipping date, to be free of defects in material and workmanship.
2) Warranty Performance: During the above two (2) years warranty period, a product with a defect will
be replaced with a new one when the product is returned to the manufacturer. The replacement
product will be in warranty for the balance of the original two (2) years warranty period.
3) This warranty is void if the product has been damaged by accident, in shipment,
unreasonable use, misuse, neglect, improper service, commercial use, repairs by unauthorized
personnel or other causes not arising out of defects in materials or workmanship.
CAUSE
The charger is overheat
1) Open-circuit
2) Dirty Battery Posts
3) Dead Battery
4) Output Short Circuit
Charging in 12V Mode(s)
for 24V battery
Battery cannot store elec-
tric or cannot be recovered
through Repair Mode
Reverse Polarity
Overload in SUPPLY Mode
(will automatically shut
down for 30 seconds as
protection)
The charging will automatically pause.
Do NOT cut off the power supply, and the
charger will work again when cooled down.
1) Connect the red and black clamps to the battery posts
2) Clean the battery posts
3) Replace the battery with a new one immediately
4) Disconnect red and black output terminals
Please restart the charger and choose
the correct charge mode
1) Replace the battery with a new one
2) If REPAIR Mode has not be tried, try it for recovery
Exchange the red and black clamps
to the correct battery posts
Disconnect the external device
SOLUTION
// USER GUIDE_EN 9