Troy-Bilt 020240 Manual Del Operario página 17

Section 5: Maintenance
Pump Maintenance
Changing Pump oim
Change oil every 50 hours or once yearly, whichever
occurs first.
NOTE: Purchase a premeasured bottle of pump oil item
number 190586GS, by contacting the nearest authorized
service center.
Change
pump oil as follows:
I. Drain engine oil and fuel from pressure washer.
2. Use a 8ram allen wrench to remove bhck pump oil cap
between high pressure outlet and garden hose inlet
(Figure 24).
ENGmNE MAmNTENANCE
See the engine operator's manual for instructions on how
to properly maintain the engine.
CAUTION
Used motor oil has been shown to cause skin cancer in
certain laboratory animals,
Thoroughly wash exposed areas with soap and water_
KEEP OUT OF REACH OF CHILDREN. DON'T
POLLUTE. CONSERVE RESOURCES. RETURN
USED OILTO COLLECTION CENTERS.
Oil Cap
3. Tilt pressure washer to drain oil into an approved
container until it drips slowly from pump.
4. Tilt pressure washer in opposite direction and empty
premeasured pump oil bottle into same opening (a
small funnel may be helpful).
5. Install bhck pump oil cap and tighten firmly.
6. Set pressure washer in upright position.Add fuel and
engine oil.
D ata Ta_
Data tag information is very important if you need help from
our Customer Service Department or an authorized service
dealer.
o The data tag (Figure 25) is located on the base of the
pressure washer. For future reference, please copy the
model revision, and serial number of the pressure washer
in the space below.
MOOEL [
REM NO [__
SERIAL [__
PSi
GPM
[
[
Copy Model
Number Here
Copy Revision
Here
Copy Serial
Number Here
41@