Troy-Bilt 020240 Manual Del Operario página 8

Section 3: Assembly
2, Insert carriage boHts through holies from outside of unit
and at_ch a pHastic knob from inside of unit (Figure 2).
Tighten by hand.
%
3, PHace accessory tray over holieson handHe (viewing
from front of unit). Pushthe tree chipsinto the holies
untiHthey sit fiat against the accessory tray (Figure 3).
4, Insert"L" boHt through hoHe just above biHHboardon Heft
side of handHe (viewing from front of unit). HoHd boHt in
pHaceand attach a pHastic knob from inside of unit
(Figure 4).Tighten by hand.
!l
Spray Gun Hook
5, Insert muHti-coHored ProjectPro TMnozzHes and other
suppHied accessories in spaces provided in accessory
tray, See "How to Use AccessoryTray',
Add [_rig[ne Oil and Fuel
° PHacepressure washer on a HeveH surface,
• Refer to engine opera_:or's manual for oil and fueJ fii[
informa!:iom
• Damage to equipment resulting from failure _:ofollow this
instrud:ion will void warrant:},;
o Refer to engine operator's manuaHand follow oiH and fueH
recommendations and instructions,
NOTE: Check oi[ often during engine break-in, Refer to
engine operator's manua[ for recommendations,
0