Control Buttons - Cameo CLP56Q8W Manual De Usuario

CONNECTIONS, CONTROLS AND INDICATORS:
DISPLAY
1
The four digit LED display shows the operating mode and other system information. The illumination of the
display switches off automatically after approx. 90 seconds of inactivity. Pressing one of the 4 control buttons
will turn the illumination of the display on again.

CONTROL BUTTONS

2
MODE: Selection of the standalone functions, DMX modes, and DMX address.
ENTER: Makes it possible to change a value and confirm changes.
UP and DOWN buttons: Press the UP and DOWN buttons, for example, to adjust the microphone sensitivity,
change the stroboscope speed or DMX address.
DMX IN
3
3-pin male XLR socket for connection of a DMX controller (e.g. DMX Mixer).
4 DMX OUT
3-pin XLR socket for looping through the DMX control signal.
FUSE HOLDER
5
IMPORTANT INFORMATION: Replace the fuse only with a fuse of the same type and rating. If the fuse blows
repeatedly, please contact an authorised service centre.
9