Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING: make sure that the covers of both tanks are securely closed before use. Make sure
that the waste water tank is correctly installed (as this tank can be removed to facilitate the
disposal of dirty water).
Box content
-
Main unit
-
Liquids head and bristle brush
-
Clean-water tank
-
Waste-water tank
-
Instruction manual
3. OPERATION
Assembly and first cleaning
It is recommended to clean the appliance before first use to remove any manufacturing
residues that may remain in the clean water tank. Carry out the following steps:
1. Fill the clean water tank completely.
Note:
Only use tap, alkaline or ionised water.
Make sure the covers of both tanks are completely closed before using the appliance.
2. Make sure that the suction filter is in its position in the waste water tank.
3. Connect the flexible hose to the main unit. Then, connect the spray/suction head to the end
of the hose. Make sure that the locking devices remain in the closed position. Fig. 2
4. Insert the spray head into a bucket or similar container and empty the clean water tank
completely by repeatedly pressing the spray trigger.
Water spraying
1. The clean water tank is located in the rear part of the appliance. Remove it, turn it over so
that the plug faces upwards and unscrew it. Fig. 3
2. Fill the tank with 1.4 L of water, up to the MAX mark. Once filled, replace the plug. Then,
return the tank to its original position.
3. Plug the equipment in and turn it on by pressing the power button.
4. Hold the suction nozzle by the handle and hold it over the area to be cleaned.
5. Press the spray trigger to spray water on the surface to be cleaned.
CONGA 5000 CARPET&SPOT CLEAN
ENGLISH
49
Publicidad
