cecotec CONGA 5000 CARPET&SPOT CLEAN Manual De Instrucciones página 52

ENGLISH
5. TROUBLESHOOTING
Troubleshooting
PROBLEM
The appliance
does not work
The appliance
does not spray
Water is not
sucked in
correctly
52
CONGA 5000 CARPET&SPOT CLEAN
CAUSE
It is not plugged in.
The plug does not work.
Protection against
overheating of the motor
is activated.
Water tank is out of
water.
The suction hose is dirty
or clogged.
The spray trigger is stuck
or broken.
The appliance is not
plugged in.
Waste water tank is not
assembled correctly.
Automatic vacuuming
stop.
The suction hose is dirty
or clogged.
The suction filter or the
cover is clogged.
SOLUTION
Make sure that the plug has been correctly
inserted into a power socket.
Check the socket with another appliance.
Check whether a fuse in the fuse box has
tripped.
Turn off and unplug the appliance. Wait for
it to cool down completely before using it
again.
Fill the water tank with 1.4 l of clean water.
Clean the suction hose.
Release the trigger and try to pull it again.
If spraying still does not occur, contact the
official Cecotec Technical Support Service.
Plug the device in.
Remove and re-install the waste water tank.
Make sure it is correctly positioned before
further use.
Turn off the appliance and empty the waste
water tank.
Clean the suction hose. Check if it is
damaged.
Clean the filter.