'4
Use _1/1_ to setectthe
desired location setting, then
press OK.
_3
Initial Setup
This section will guide you through
the unit's initial setting
which includes
selecting a language for your on-screen
menu
and autoprogram,
which automatically
scans and memorizes
viewable
channels.
Before you be£in:
Make sure the unit is connected
to antenna
or cable.
2
After making all the necessary connections,
press _ to turn on the unit,
• It may take a few moments to turn on the unit for the
first time,
• [Initial Setup]
menu appears
automatically
after the
unit is turned on,
Use A/¥
to select the on-screen tanguage from the
choices (English / Espafiol/Frangais) on the right side of the
TV screen,
3
Use A/¥
to select [Antenna] for TV channels or [Cable]
for CATV channels, then press OK.
• [Autoprogram]
will begin.
• Select [Retail] store, the unit wilt be set up with
Note
predefined setting for retail displays, In this setting, the
power consumption
may possibly exceed the limited
requirement
of the ENERGY STAR ® qualification.
Select [Home], the unit is set to maximize the energy
efficiency for home setting and it can be adjusted
through a choice of picture and sound quality according
to your preference.
When the initial setup is completed, the lowest
memorized
channel with the confirmation
message of
the location setting will be displayed on theW
screen.
If you are not receiving
a signal from your cable service, contact the Cable
provider:
If you press _ or MENU
during
autoprogram,
this setting
will be canceled.
The initial autoprogram
function
can be executed
for either
[Antenna]
or
[Cable]
only once,When
you change the connection
(Antenna/Cable),
set [Autoprogram]
again, ,,_ p.19
If there is no signal input from the antenna ter-minal
and no operation
for
several seconds
after you turn on the unit, [Helpful
Hints]
appears,
Follow
the instructions
lisced on theTV
screen.
You must set [Home]
in step 4, Otherwise,
the settings of picture
and
sound quality
you adjusced will not be memorized
after- you turn
offthe
unit.
g
_z
,>
(/:
i,:,ii!
q
;>
After an initial setup is completed...
• If you want to scan the channels automatically
again,
[Autoprogram]
"'_ p.19
• You can add the desired cable and analog channeis
unmemorized
by autoprogram.
[Add Channels]
,,,_p.20
• If you want to change to another language.
[Language Selection]
'"_ p.21
• If you want to change the location setting.
[Location]
'"_"p.30
15
EN