Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Instructions – IFLD Infrastructure Flood
Photocontrol - If Equipped (Figure 12)
If your luminaire is equipped with a photocontrol
N
ote:
receptacle, see IB525002EN Photocontrol Receptacle
Supplement to identify your photocontrol and follow
the instructions on the diagram and all applicable
notes.
Figure 12.
Maintenance
N
ote:
A regular maintenance schedule should be
followed to retain optimal light output and thermal
performance. Optical lens cleaning should be
performed with a clean dry cloth to remove any dust
or other contaminants. Additional cleaning can be
performed with using a non-abrasive polycarbonate
polycarbonate cleaner. Remove any dirt, leaves
or other foreign debris from the housing. cleaner.
Remove any dirt, leaves or other foreign debris from
.
the housing
Accessories Mounting
Wire Guard (Figure 13)
Tools Required:
Torx screwdriver T20, #2 philips screw
driver.
1.
Loosen and remove the existing (4) 8-32 torx screws on
the face of the fixture (Fig 13).
2.
Align wire guard on top of lens clips matching the four
existing holes.
3.
Use (4) 8-32 philips screws provided to tighten the
wireguard in place onto each LED square.
4.
To remove wire guard, follow steps 1-3 in reverse order.
6
Cooper Lighting Solutions
IB506022EN
Installation instructions
Figure 13.
Vandal Shield (Figure 14)
Tools Required:
Torx screwdriver T20, #2 philips screw
driver.
1.
Loosen and remove the existing (4) 8-32 screws on the
face of the fixture (Fig 14).
2.
Align (4) 7/8" long spacers with existing holes (4).
3.
Use (4) 8-32 x 1-1/2" screws to secure vandal shield on
top of fixture.
4.
To remove vandal shield, follow steps 1-3 in reverse
order.
Figure 14.
Publicidad
