Coolbox GUARDIAN 3 1K Manual De Usuario página 8

EN
1: AC input
2: Output sockets
4: USB & RS232
5: RJ45 (optional)
6: Automatic switch
HOW TO USE:
1: Charging
This unit is shipped from the factory with its internal battery fully charged.
However, some charge may be lost during shipping, and the battery should
be recharged before use. Turn on the UPS, plug the unit into an appropriate
power source, and allow the UPS to fully charge by leaving it plugged in
for at least 6 hours without load (without electrical devices like computers,
monitors, etc., connected).
2: Placement
Install the UPS unit in a protected environment that provides adequate
airflow around the unit and is free from excessive dust, corrosive fumes,
and conductive contaminants. Do not operate your UPS in an environment
where the ambient temperature is high and/or humid. Also, place the UPS
at least 20cm away from the monitor to avoid interference.
3: Connection
Plug the UPS into a grounded 2-pole, 3-wire power outlet. Then connect
a computer-related device to each of the power sockets provided on the
back of the UPS.
4: Power On/Off
To turn on the UPS unit, press the power switch lightly. To turn off the UPS
unit, press the power switch again.
SPECIFICATIONS:
MODEL: GUARDIAN 3 1K
CAPACITY: 1000VA / 600W
INPUT
Voltage: 220/230/240 VAC
Voltage Range: 162~268 VAC
Frequency Range: 60/50Hz (auto-detection)
OUTPUT
Voltage: 220/230/240 VAC
Regulation (Battery Mode): +/- 10%
Frequency Range (Battery Mode): 60Hz or 50Hz +/- 1Hz
Transfer Time: 2 ~ 6 ms (typical)
Waveform (Battery Mode): Simulated sine wave
BATTERY
Type and Quantity: 12V / 7 Ah x 2