Levenhuk Ermenrich NetGeeks NP60 Guia Del Usuario página 4

Ermenrich NetGeeks NP60 Optical Wire Tracker
EN
Please carefully read the safety instructions and the user manual before using this product. Keep away from children. Use the device only as
specified in the user manual.
The kit includes: transmitter, receiver, RJ11 patch cord, RJ45 patch cord, alligator clip, Type-C USB cable, DC cable, earbuds, carry bag,
user manual, and warranty.
Charging the device
The transmitter and the receiver use rechargeable lithium polymer batteries. Connect the Type-C USB cable to the device and the DC
adapter via a USB plug and connect it to the AC power supply to charge the device.
Getting started
Transmitter
Press and hold the power button (6) for 3 seconds to turn the transmitter on/off.
Press the OK button (7) to enter the menu, press the Up (8) and Down (9) buttons to scroll the menu. Press the OK button (7) to
confirm the selection. Press the Back button (10) to return.
Receiver
Press and hold the power button (22) for 3 seconds to turn the receiver on/off.
The default mode is the digital detection mode.
Blue triangles on the screen indicate the selected items. Green triangles on the screen point at the device ports for cable connection.
Display icons
Wire mapping
This function is used to check if the wires within the cable are connected correctly.
Plug one end of the cable into the QC/CONT port (5) on the transmitter and the other end into the RJ45 port (24) on the receiver.
1.
2. Select CONT (Wire mapping) in the main menu, choose the required cable type, and press the OK button (7).
Possible outcomes are shown below:
Display information
Function
Wire mapping
Port Flash
PoE test
Optical power meter
Settings
Normal
Open
Display icons
4
Function
Cable tracing
Cable length measurement
Cable crimping quality check
Visual fault locator
Short
Cross