Publicidad
Idiomas disponibles
Idiomas disponibles
4.1
Mounting location
■
Ideally, the toilet should be installed in a location that is higher than the holding tank. A
(maximum) 6' rise between the toilet and holding tank will not impact performance.
Using toilet and supplied template, verify that the installation site has:
■
o Sufficient clearance between toilet and nearby wall so that water supply hose and
discharge hose are not kinked
o Room for maintenance and accessibility
■
The floor supporting the toilet is level and strong enough to support toilet and weight of any
potential user.
■
The floor structure is strong enough to securely anchor toilet using supplied screws; 3/4"
minimum.
■
The flooring is water-resistant so structure and anchoring integrity are maintained.
4.2
Raw water considerations
■
The Raw Water pump must be securely mounted in a dry, well-ventilated area. It should be
mounted not more than 6' at any time above the heeled waterline.
DANGER: The Raw Water pump must be powered by the toilet relay module. Use of any pump
that draws more than 15 amps requires installation of a pump contactor relay. Do not wire
pump directly to a D.C. power source so that it is controlled by its pressure-activated switch. If a
leak were to occur when wired directly, the pump would run continuously and create risk of
sinking of the boat and loss of life.
■
An in-line strainer MUST be installed to protect the system. Failure to use an in-line strainer may
void product warranty.
A Vented Loop of proper diameter MUST be installed if – UNDER ANY CIRCUMSTANCE or
■
CONDITION (including heel trim or load):
o Toilet is connected to a through-the-hull fitting and rim of toilet could EVER be in a
position below the waterline.
DANGER: Failure to use a Vented Loop in raw water pump installation sites can lead to water
flowing into the toilet from the outside (siphoning) which can cause loss of property and life!
4.3
Required tools
■ 1-1/4" hole saw
■ 1 3/4" - 2" hole saw
■ 3-1/2" hole saw
■ 7/16" socket and ratchet or 7/16" wrench
■ Electric drill
■ 1/8" drill bit
Tecma S.r.l.
Via Flaminia | Loc. Castello delle Formiche
05030 Otricoli (TR)
ITALY
Compass ECO | installation manual NA | ENG
10
T +39 0744 709071
info@tecma.eu
www.thetfordmarine.com
Publicidad
