Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly - Hanging the Fan
1
Remove the mounting plate
from the motor assembly
□
Remove the mounting plate (A) from the fan motor housing
(C) by removing all three screws (SS) from the round holes.
This will enable you to remove the mounting plate (A).
A
2
□
□
□
SS
C
□
7
Attaching the fan to the
electrical box
NOTE: For better fan performance, make sure the
mounting plate is level. Additional washers (HH) (not
included) may be needed to insert between the outlet box
and mounting plate.
Turn the power off.
Loosen the two mounting screws (GG) supplied with the
outlet box (FF), but do not remove.
Securely attach the mounting plate (A) to the outlet box (FF)
by sliding the mounting plate (A) over the two mounting
screws (GG) supplied with the outlet box. Pull the 120-volt
supply wires through the hole in the mounting plate (A) and
lay them to the side.
Securely tighten the two mounting screws (GG).
120V Wires
Please contact 1-855-HD-HAMPTON for further assistance.
FF
GG
HH
A
HAMPTONBAY.COM
Publicidad
