Craftsman 152.211640 Manual Del Usuario página 8

13
6
15
16
12
14
11
7
10
QUmCK CHANGE WHEEL COVER - Covers the
grinding wheeUs and provides quick access for
routine maintenance,
2, QUICK RELEASE KNOB - Remove knob to allow
the Quick Change Wheel Cover to be removed,
3, SPARK ARRESTOR - Prevents hot sparks and
debris from contacting the operator,
4, FLEXIBLE WORK LIGHT - Provides light to the
operator during set up or grinding operations,
5, WHEEL DRESSER - Used to eUeanand smooth
front surface of the grinding wheel
6, INNER WHEEL GUARD - Covers the grinding
wheeUs and protects against aecidentaU contact,
7, EYESHIELD - Protective Lexan see-thru shieUds to
prevent any Uoosedebris from contacting the operator,
8, GRINDING WHEEL 60 GRIT - Used to remove Hght
matedaU from workpieee,
9, TOOL RESTS - Used to support the workpiece that
is being ground, AdjustaHe to provide angUedsurface,
10, DRILL BIT SHARPENING PLATE - Used to sharp-
en twist ddH bits, ShouUd be removed for reguUar
grinding operations,
11, TOOL REST ADJUSTABLE SUPPORTS - Lets the
operator position the tooU rest closer to the wheeU as
the wheeU decreases in diameter due to wear,
12, ON-OFF SWITCH - Used to turn ON and turn OFF
the grinder,
13, GRINDING WHEEL 36 GRIT - Used to remove
heavy matedaU from workpiece,
14, GRINDING WHEEL IDENTIFICATION LABEL -
Provides information on wheel size, grit and maxi-
mum rpm, Must be left on to distribute the load of
tightening the lock nuts,
15, FLANGES - Used to secure the grinding wheels to
the grinder and distribute the load of the Lock Nuts,
16, ARBOR HEX NUT - Used to secure the grinding
wheels to the grinder,
17, SPACER (not shown) - Used to align the wire wheel
or buffing wheel into the center of the tool rest,