Descargar Imprimir esta página

Toro eTimeCutter 75841 Manual Del Operador página 55

Cortacésped de asiento de 107 o 137 cm (42" o 54")

Publicidad

Idiomas disponibles

Idiomas disponibles

Blade Service (continued)
Sharpening the Blades
1. Use a file to sharpen the cutting edge at both
ends of the blade. Ensure to maintain the
original angle
Note:
from both cutting edges so that the blade
retains its balance.
2. Check the balance of the blade
on a blade balancer
Note:
position, the blade is balanced and can be
used.
If the blade is not balanced, file some metal off the end of the sail area only.
3. Repeat this procedure until the blade is balanced.
Installing the Blades
Operating a machine after incorrectly installing the blade assembly and/or not using
genuine Toro blade and blade hardware could allow a blade or blade component to be
thrown out from under the deck, resulting in serious injury or death.
Always install genuine Toro blades and blade hardware according to the instructions.
1. Install the blade as shown.
Note:
pointing upward toward the inside of the
mower to ensure proper cutting.
2. Torque the blade bolt to 81 to 108 N·m (60 to
80 ft-lb).
3463-565A
.
Remove the same amount of material
.
If the blade stays in a horizontal
The curved part of the blade must be
G000552s
by putting it
G000553s
WARNING
G448104
Page 5–9
Maintenance: Mower-Deck Maintenance

Publicidad

loading

Este manual también es adecuado para:

Etimecutter 75851