ST MH 500 Li 48 Manual De Instrucciones página 137

J. Battery charger (accessory available
upon request, par. 15.2): device used to
recharge the battery; its specifications
and directions for use are described in
a specific manual. Two battery chargers
are available: J1 (fast battery charger);
J2 (standard battery charger).
K. Battery backpack (accessory on request.
par.15.3): device used to store batteries.
L. Connection cable: cable used to connect
the machine to the battery pack.
M. Battery simulator (accessory on
request. par.15.4): device that allows
the use of the battery backpack when
inserted in the machine housing.
4. ASSEMBLY
The safety regulations to follow
are described in chap. 2. Strictly
comply with these instructions to
avoid serious risks or dangers.
For storage and transport purposes, some
components of the machine may not be installed
in the factory and have to be assembled after
unpacking. Follow the instructions below.
Unpacking and completing the assembly
should be done on a flat and stable surface,
with enough space for machine handling
and its packaging, always making use of
suitable equipment. Do not use the machine
until all the instructions provided in the
"ASSEMBLY" section have been carried out.
4.1 ASSEMBLY COMPONENTS
The packaging includes assembly components.
4.1.1 Unpacking
1. Carefully open the packaging, paying
attention not to lose components.
2. Consult the documentation in the
box, including these instructions.
3. Remove all the unassembled
parts from the box.
4. Remove the machine from the box.
5. Dispose of the box and packaging in
compliance with local regulations.
4.2 ASSEMBLY OF THE HEDGE
TRIMMER DEVICE
Before assembling, make sure the
battery is not fitted in its housing.
• Insert the control rod (Fig. 3.A) in the
hedge trimmer device (Fig. 3.B).
• Slide the collar (Fig. 3.C) upwards and
turn it clockwise until it is fully tightened.
Periodically check that the
joints are well tightened.
4.3 EXTENSION OF THE HEDGE
TRIMMER DEVICE
• Loosen the knob (Fig. 4.A) following the
direction of the arrow - open padlock;
• pull or push the rod (Fig. 4.B) until
it reaches the desired length;
• when the adjustment is complete, tighten
the hand grip following the direction
of the arrow - closed padlock.
Periodically check that the
joints are well tightened.
4.4 REMOVING THE HEDGE
TRIMMER DEVICE
• To remove the hedge trimmer device
(Fig. 3.B), place the control rod (Fig. 3.A) on
the ground, loosen the collar (Fig. 3.C) and
disassemble the hedge trimmer device.
4.5 BATTERY BACKPACK
SETTING (IF PROVIDED)
The battery
assembled (Fig.1K) and can be detached from
the harness holder (Fig. 5) and carried by hand.
To detach the battery pack, press the two top
buttons (Fig. 5.A).
The battery housings are located on both sides
of the backpack (Fig. 6)
On the right side of the backpack there are:
• cable socket (Fig. 7.A);
• a battery selector switch (Fig. 7.B);
• a USB port for charging other devices (e.g.
mobile phones) (Fig. 7.C).
In order to avoid the presence of loose cables,
there are slots positioned on both sides and in
the back, which can be used to run the power
cable through.
EN - 7
backpack comes already