Publicidad
Idiomas disponibles
Idiomas disponibles
13. MAINTENANCE TABLE
Intervention
MACHINE
Check all fasteners
Safety checks/check controls
Check rod fastening
Check the battery charge status
Recharge the battery
Cleaning the machine and the motor
Cleaning and lubrication of the cutting means
Checking for any damage to the machine. If
necessary, contact the authorised service centre.
Checking the cutting means
Sharpening the cutting means
Replacing the cutting means
* Refer to the battery/battery charger manual.
** The operation must be carried out by your Dealer or an Authorised Service Centre
14. TROUBLESHOOTING
PROBLEM
1. When the safety button
is activated, the blue light
on the safety button (Fig.
8.C) does not light up.
2. When the safety button
is pressed, the blue light
(Fig. 8.C) does not light up,
the control light flashes
3. The motor shuts down
whilst working
4. With the throttle trigger lever
(Fig. 8.A)and the locking lever
(Fig. 8.B) when activated the
cutting device does not rotate
5. The cutting means
overheats whilst working
6. The cutting means comes
into contact with a line
or electric cable
Before each use
Before each use
Before each use
Before each use
After each use
After each use
After each use
After each use
After each use
PROBABLE CAUSE
Battery is not inserted or
is inserted incorrectly
Low battery
Battery is not inserted correctly
Machine damaged
Machine damaged.
Insufficient blade lubrication
-
EN - 14
Frequency
-
-
Make sure that the battery is
inserted correctly (par. 7.2.3)
Check the battery status and
recharge if necessary (par. 7.2.2)
Make sure that the battery is
inserted correctly (par. 7.2.3)
Do not use the machine Remove the
battery and Contact a Service Centre.
Do not use the machine. Immediately
turn off the machine, remove the battery
and Contact a Service Centre.
Turn off the machine, wait until the cutting
means is stationary, remove the battery
and lubricate the blades (par. 7.4)
DO NOT TOUCH THE BLADE AS IT MAY
BE LIVE AND EXTREMELY DANGEROUS!
Grasp the machine using the insulated
rear hand grip only and position it at a
safe distance from yourself. Disconnect
the current that powers the severed
line or mains cable and remove the
battery before freeing the blade teeth.
Notes
par. 7.5
par. 6.2
4.3, 4.4
*
par. 7.2.2
*
par. 7.3
par. 7.4
-
par. 8.1.1
par. 8.1.2
**
par. 8.1.3
**
SOLUTION
Publicidad
