Audi 8W9.071.151 Manual De Instrucciones página 32

Installation instructions - Audi A4 (8W) Avant 2016 ►
Edition 07.2015
– To install the add-on components, remove the profile cap
-17- from the profile tube -2- -arrow A-.
– Insert the add-on components in the T groove -arrow B-.
– Slide the profile cap -17- back on -arrow C-.
When the add-on components are not in use, secure the T
groove with the profile cover -1-.
– Adjust the profile cover -1- to the length of the profile tubes
with the profile caps -17- closed.
– Position profile cover -1- on the profile tube and press it into
the T groove -arrow-.
Note
◆ When driving with a roof load, make sure that the German
Road Traffic Regulations (StVZO) or any country-specific
regulations are observed.
◆ For reasons of convenience, it is common for the carrier
units with/without roof rack modules to remain on the vehi-
cle, even if they are not in use. As a result of the increased
wind resistance, your vehicle will consume more fuel and will
produce additional noise.
◆ We therefore recommend that you remove the roof bars af-
ter use.
◆ Increased wind noise can result from driving with the roof
bars attached.
4.3 Removing the carrier units
Note
The carrier units must be removed by two people.
– Remove the load and the add-on components.
– Open the cover flap -12-.
– Loosen the left and right tensioning bolts -13- alternately.
– Unscrew the tensioning bolts -13- alternately until a slight re-
sistance is felt.
12
4 Installing/removing the carrier units