Resharpened Saw Blades; Accessories; Parallel Stop, Table Widener; Side-Mounted Cover, False Joints - Festool TS 55 REQ Manual De Instrucciones

Resharpened saw blades

The cutting depth of resharpened saw blades can
be adjusted accurately using the adjusting screw
[11-1].
Adjust the cutting depth stop [11-2] to 0 mm
(with guide rail).
Unlock the saw unit and push downwards until
it reaches the stop.
Turn in the adjusting screw [11-1] until the saw
blade touches the workpiece.
Use only original Festool accessories and Festool
consumable material intended for this machine be-
cause these components are designed specifically
for the machine. Using accessories and consum-
able material from other suppliers will most likely
affect the quality of your working results and limit
any warranty claims. Machine wear or your own
personal workload may increase depending on the
application. Protect yourself and your machine, and
preserve your warranty claims by always using
original Festool accessories and Festool consum-
able material!
The order numbers of the accessories and tools can
be found in the Festool catalogue or on the Internet
under "www.festool.com".
Saw blades, other accessories
In order to saw different materials quickly and
cleanly, Festool offers saw blades for all applica-
18
11

Accessories

tions that are specially designed for your Festool
portable circular saw.

Parallel stop, table widener

A parallel stop can be used for section widths up to
180 mm. The parallel stop can also be used as a ta-
ble widener.

Side-mounted cover, false joints

The cover that can be mounted on the side of the
protective cover improves the effect of dust extrac-
tion for 0° cuts.
Simultaneously, the cover can be used as a false
joint stop for false joint widths from 18 mm on-
wards.
The guide rails, which are available in different
lengths, allow for precise, clean cuts and simulta-
neously protect the workpiece surface against
damage.
In conjunction with the extensive range of accesso-
ries, exact angled cuts, mitre cuts and fitting work
can be completed with the guide system. The option
11-1
Guide system
11-2