PURLINE VENTY ARGENTUM Manual De Instrucciones página 15

ASSEMBLY INSTRUCTIONS
1. Place 3 drywall plugs(3) into wall where bracket(2) is to be attached.
2. Mount the hanging bracket(2) on the wall with the three screws provided(1). (Fig.1)
3.
Hang the fan using the hook(11) of the rear mounting plate(12) onto the hanging bracket(2)
attached to the wall. Place Bracket Screw(14) through fan and thread screw on to bracket.
(Fig. 2 & 3)
4. Loosen rear grille securing nut(6) from the motor housing (A).
5. Position rear grille(5) firmly to motor housing (A) and then fasten by turning rear grille
securing nut (6) clockwise till tightened.
6. Insert the fan blade(7) onto the motor shaft pin(13), matching the slot on the back of the
blade with the shaft pin. Secure the fan blade using the fan blade securing cap(8), turning
counter-clockwise to tighten.
7. Install front grille (9) by aligning position hook (10) on front grille over top of the rear grille.
Fasten the two grilles with all clips and a screw & nut attached.
Fig. 1 Fig. 2 Fig. 3
EN
15