Publicidad
Idiomas disponibles
Idiomas disponibles
In order to attach the AX-TRUSS to the box, firstly the
screw on the upper rear side must be backed out a few
turns (1). Then the rear side screw must be
1
Back out few turns
Back out few turns
2
Remove screw
Remove screw
The next step will be to secure the fixing hardware part to the truss. In order to do so, the nut and the wing
nut must be tightened. Make sure that the fixing hardware has been secured tightly to the truss, and that it is not able
to swing. This way both parts of the rigging hardware will be fixed: one to the truss and the other one to the box.
Note: Maximum load capacity for AX-TRUSS is 50 kg. Never exceed this limit.
Once the fixing hardware has been attached to the truss, then the box can be attached (5).
5
RF Series
the base of the AX-TRUSS will be placed on the corner,
making sure that the head of the upper screw fits into
the slot (3) on the base. Then the special rear side
screw, provided with the hardware (4), will be fixed to
the box.
Special screw M10x60
Special screw M10x60
The vertical splay angle
depends on the hole where the quick
release pin has been inserted (6).
Manual del usuario/ User´s manual
Once the rear side screw has been removed,
Slot
3
4
6
31
Publicidad
