Publicidad
Idiomas disponibles
Idiomas disponibles
4.5 Rigging with AXA
AX-2RF12 / AX-2RF15 Array Frame.
Mounting instructions.
1.- Flip the speakers upside down. Remove the
existing speaker screws and rubber feet. Replace the
screws used to attach the rubber feet to keep air from
escaping.
2.- Position the speakers in the desired splay angle.
3.- Attach the joining plates to the enclosure using the
holes on the concave side for the rear and the holes on
the convex side to determine the angle. The holes
closest to each other position the enclosures side to
side, forming a 20º angle between them. Advancing
toward the exterior alternate holes on each side
increment the angles in 5º steps. It is recommended
that the joining plate be placed as symetrically as
pos-sible. Flat washers should be placed adjacent to
the joining plates, followed by the lock washer and
finally the bolt.
4.- Slowly flip the speaker assembly so that the tops of
the speakers are facing up.
5.- Screw the joining plates to the enclosures
positioning the one with rigging points in the rear so a
pull point is available should we need steep vertical
angling.
6.- Screw the eyebolts into the two remaining holes.
7.- Suspend the enclosures using the eyebolts and the
joining plate with rigging points.
Package contents
4 joining plates (1 with rigging points) 8 M10x30
screws, 8 Grower (split) M10 lock washers, 8 M10
flat washers, 2 M10 eyebolts, 1 number 8 Allen
(hex) wrench, 1 number 6 Allen wrench.
Manual del usuario/ User´s manual
RF Series
32
Publicidad
