Publicidad
Idiomas disponibles
Idiomas disponibles
AX-2RF12 / AX-2RF15 Array Frame.
Mounting instructions.
1.- Flip the speakers upside down. Remove the
existing speaker screws and rubber feet. Replace the
screws used to attach the rubber feet to keep air from
escaping.
2.- Position the speakers in the desired splay angle.
3.-Attach the joining plates to the enclosures using
the short plates in front and the longer plates in the
rear (see drawing). The holes closest to each other
position the enclosures side to side, forming a 20º
angle between them. Advancing toward the exterior
alternate holes on each side increment the angles in
5º steps. It is recommended that the joining plate be
placed as symetrically as pos-sible. On the rear
joining plates are two rows of holes on each side. The
outer holes are for RF enclosures with a 15" bass and
the internal holes are for units with a 12" bass. Flat
washers should be placed adjacent to the joining
plates, followed by the lock washer and finally the
bolt.
4.- Slowly flip the speaker assembly so that the tops of
the speakers are facing up.
5.- Screw the joining plates with rigging points to on
the top-front of the enclosure.
6.- Screw the rear joining plates to the enclosures
using a screw in the center and eyebolts on the ends.
If steep vertical angling is needed, the rear plate can
be attached with 3 screws and the eyebolts can be
used in the rear (with-out washers in this case) panel
of the cabinet.
7.- Suspend the enclosures using the eyebolts and the
joining plate with rigging points.
Package contents
4 joining plates (2 with rigging points), 2 rear joining
plates, 14 M10x30 screws, 14 Grower (split) M10
lock washers, 14 M10 flat washers, 2 M10 eyebolts, 1
number 8 Allen (hex) wrench, 1 number 6 Allen
wrench.
Manual del usuario/ User´s manual
RF Series
34
Publicidad
