Publicidad
Idiomas disponibles
Idiomas disponibles
Electrical Connections
Risk of severe injury or death by electrical shock.
• Always disconnect the electrical power before touching the pump, discharge or electrical plug when water is
present in the area.
• Do not use the power cord for lifting the pump.
• Be certain that this pump is connected to a circuit equipped with a ground fault circuit interrupter (GFCI) device if
required by code.
Connect the power cord to a constant source of power match-
ing the pump nameplate voltage.
• Connect the pump to its own circuit, with no other
electric receptacles or equipment in the circuit.
NOTE: Do not connect to a fan or any device that runs
intermittently.
• The fuses or circuit breaker should use a 15 A breaker.
IMPORTANT: If the power cord is damaged, the whole
unit must be replaced.
The automatic pumps have piggyback plugs on the switch
cords.
1. Plug the pump cord into the float switch cord.
2. Plug the float switch cord into the outlet.
INSTALLATION
Electrical Connections
Cap
115 V Plug
A-N613
Pump
Manual
M
Ground
Automatic
5
Publicidad
