Before You Begin; Ducting - ELICA ESNX43S1 Guía De Instalación, Uso Y Mantenimiento

The manufacturer declines all responsibility in
the event of failure to observe the instructions
given here for installation,
suitable operation
manufacturer further declines all responsibility
for injury due to negligence and the warranty of
the unit automatically expires due to improper
maintenance and/or installation.
6" round ducting must be
through the ceiling, in line with the central
vertical axis of the range hood.
This unit must have it's own ductwork. Do not
under any circumstances vent this unit into any
other ductwork or
building.
Furthermore, please read carefully all of the
following installation instructions.
- Use an exhausting pipe whose maximum length
does not exceed 5 meters.
- Limit the no. of elbows in the piping, since
each elbow reduces the air capacity
of 1 linear meter. (Ex.: if you use no. 2 x 90 °
elbows, the length of piping
meters).
- Avoid abrupt direction changes.
- Use a 6" constant diameter pipe for the whole
length.
- Use piping approved by standards in force.
6

BEFORE YOU BEGIN

maintenance
of the product.

DUCTING

available for the hood
exhaust ducting in
must not exceed 3
BEFORE YOU BEGIN: It is advisable to test run
the range hood before installation.
and
The BEFORE STARTING
document and ensure
with the require-ments and limitations. These
units weigh approximately 55lbs and therefore
require a minimum of two people to install.
CAUTION: FOR GAS RANGE & COOKTOP INSTALLATIONS:
MOUNT THIS HOOD SO THAT THE BOTTOM EDGE IS AT
LEAST 30" ABOVE THE COOKING SURFACE AND NO
GREATER THAN 10'.
FOR ELECTRIC RANGE & COOKTOP INSTALLATIONS:
MOUNT THIS HOOD SO THAT THE BOTTOM EDGE IS AT
LEAST 25" ABOVE THE COOKING SURFACE AND NO
GREATER THAN 10'.
FOR RESIDENTIAL USE ONLY. PLEASE, READ
INSTALLATION MANUAL FOR SPECIFIC APPLICATION.
Use the shortest
possible. Only
ducting is generally not permitted by code. Do
not use flexible metal ducting as the ridges of
the ducting cause severe air turbulence and will
the significantly reduce the efficiency of any hood
-THIS TYPE OF DUCTING WILL REDUCE EFFICIENCY BY
50%.
Vent hoods may
exhaust gases from fire-places, gas furnaces and
gas water heaters.
drawing these lethal gases back into the home
please follow
manufacturers safety standards and guidelines.
Refer to NFPA
information.
– please read this
you are fully
most direct ductwork
use metal ducting
interrupt the proper
To minimize the
the heating
and ASHRAE for
entire
conversant
route
- plastic
flow of
risk of
equipment
additional