VEVOR HL-60ft-001 Manual De Usuario página 84

2.After determining the height, make marks on the trees on both
sides.This ensures that the wire rope is still at the correct height
when it is tightened.
The tree with the high marker point is used as the starting tree and the
other tree is used as the end tree. Attach the long mainline wire rope to the
starting tree. Pass the end of the mainline through the loop at the head and
tighten the wire so that it sets at the marked position.
3.Install a spring brake at the end of the main line wire rope.
4.Attach the Turnbuckle Cable to the tree that serves as the end point.
Then align the collars at both ends.
5.Remove the stainless steel turnbuckle screws,install the two ends
of the short wire rope aligned,and then tighten the screws with a
wrench.
6.Pass the tail end of the main wire rope through the other end of the
stainless steel turnbuckle,and then tighten the whole line.Then fix the
main wire rope with U-shaped screws.
Note: Make sure that the main line is in as tight a state as possible before
installing the U-bolts, otherwise you may not be able to fully tighten the
entire line afterwards. You can invite your partner to assist you.
- 6 -