Publicidad
Idiomas disponibles
Idiomas disponibles
Leveling of appliance
For sufficient leveling and air circulating
in the lower rear section of the
appliance, the bottom feet may need
to be adjusted. You can adjust them
manually by hand or by using a suitable
tool.
To allow the doors to self-close, tilt the
top backwards by 0.4" - 0.6"(10-15mm).
0.4"~0.6"(10-15mm)
Front roller
Adjustable
bottom feet
Adjustable
bottom feet
Note:
If required you may lay the refrigerator
on its back in order to gain access to
the base, you should rest it on soft foam
packaging or similar material to avoid
damaging the backboard of the
refrigerator.
Adjusting Door Height and Gap
The height of a door can be adjusted
using the provided Snap Rings.
Tools you will need:
To adjust the Height of Door
1. Check the height difference between
2. Insert a suitably sized Snap Ring between
1. Insert only one Snap Ring. If you insert
2. Do not raise the door too much. The
Rear roller
3. Save rermaining Snap Rings for
Snap Ring (4pcs)
Wrench(Not provided)
the doors and then lift and hold the
lowest door to be even with the other.
the Door and the Hinge as shown.
IMPORTANT !
two or more Snap Rings, they may slip
out or cause a rubbing noise.
door may contact and damage the
top cover.
possible future use.
7
Publicidad
