Publicidad
Idiomas disponibles
Idiomas disponibles
en-us_main.book.book Page 28 Monday, September 11, 2023 4:50 PM
28 INSTALLATION
1
Load the washer with 6 thick bath towels
(approximately 6 pounds).
2
Press the Power button.
3
Press the Speed Wash button.
4
Select the Start/Pause button to start the
wash cycle.
5
Make sure that water is supplied, that the
washer does not rock or vibrate excessively,
and that it drains well during the spin cycle.
NOTE
• If water leaks during water supply, see
Connecting the Water Inlet Hoses to connect
them properly.
• If the appliance rocks and vibrates excessively,
see Leveling the Appliance to level it again.
• If the drain does not work, see Connecting the
Drain Hose to install the hose properly.
Testing the Dryer
Once you have completed the installation of the
appliance, use this test to make sure the condition
of the exhaust system is adequate for proper
operation of the appliance. This test should be
performed to alert you to any serious problems in
the exhaust system of your home.
Testing Dryer Heating
Gas Models
Close the dryer door and press the Power button
to turn the dryer on. Select the Timed Dry and
Start/Pause buttons to start the test. When the
dryer starts, the igniter should ignite the main
burner.
NOTE
• If all air is not purged from the gas line, the gas
igniter may turn off before the main burner
ignites. If this happens, the igniter will reattempt
gas ignition after approximately two minutes.
Electric Models
Close the dryer door and press the Power button
to turn the dryer on. Select the Timed Dry and
Start/Pause buttons to start the test. The exhaust
air should be warm after the dryer has been
operating for 3 minutes.
Checking Airflow
Effective dryer operation requires proper airflow.
The adequacy of the airflow can be measured by
evaluating the static pressure. Static pressure in
the exhaust duct can be measured with a
manometer, placed on the exhaust duct
approximately 2 ft. (60.9 cm) from the dryer. Static
pressure in the exhaust duct should not exceed 0.6
inch (1.5 cm). The dryer should be checked while
the dryer is running with no load.
Activating the Installation Test
NOTE
• The appliance should be cool before starting this
test. If the appliance was warmed up during
installation, run the Air Dry cycle for a few
minutes to reduce the interior temperature.
• Before starting the test, please check that the
voltage is 240V±6%. If the voltage is less than
225V, a duct clogging error may occur even
though the duct is not actually clogged (electric
model only).
1
Do not load anything in the drum for this test,
as it may affect the accuracy of the results.
2
Press the Power button and touch the upper
left corner of the display 10 times slowly. And
then select Dryer after selecting Install
Mode.
Publicidad
