Bimar VT24A Folleto De Instrucciones página 8

Fax +32 030 9904733

• Before connecting the appliance, check that the voltage values shown on the data plate
240V~ 50Hz) correspond to those of the electricity supply network. In the event of
incompatibility between the electric outlet and the plug of the appliance, have the outlet replaced
with another more suitable type by professionally qualified personnel, who will make sure that the
section of the wires of the outlet is appropriate for the absorbed power of the heater. In general,
the use of adapters or extension cords is not recommended; if their use is indispensable, they must
conform to existing safety standards and their current capacity (amperes) must not be less that the
maximum of the heater.
• The power socket must be easy to reach so the plug can be removed quickly in case of
emergency.
• Do not place the fan on a shelf and/or near sinks or other container of liquids (minimum distance
of 2 meters) to avoid the risk of it falling in.
• Keep the fan far away from fabrics (curtains, etc.) or unstable materials that could obstruct the air
intake grille; make sure that the front is free of unstable materials (dust, etc.).
• Make sure that the electric cord is not touching rough, hot or moving surfaces and not twisted or
wrapped around the appliance.
• Stand the appliance on a horizontal, flat surface or table; do not stand on a inclined plane (the
appliance could upset).
• Do not place the appliance near an open flame, cooking or other heating appliance.
• Do not use the appliance with a timer or a programmer or with a system that can switch on the
appliance automatically, to avoid risk of fire, since a fire risk exists if the heater is covered or
positioned incorrectly.
• In the event of a breakdown or poor operation, turn the fan heater off and ask for professionally
qualified help.
ASSEMBLY (mod. VT34A-VT44A)
Attention: the fan can be used only when completely and correctly assembled, that is complete with
its base and protection grid. If in doubt, have the appliance checked or assembled by a qualified
professional person. For assembly, refer to figure.
Attention: always unplug the appliance before you assemble
1) Pass the cable (9) through the hole in the base and engage the base on the bottom part of the
column, making sure they are correctly positioned one against the other. Fasten the parts using the
screws provided "3" and lock them in a normal way.
2) Fasten the cable to the base using the plastic plate.
3) Insert the handle (12) in the motor casing so the 4 pins enter the corresponding slots. The handle
must be positioned correctly (upwards and towards the back part), otherwise the grid cannot be
fastened.
4) Fasten the rear grid (6) to the motor casing, positioning the corresponding pins and holes, and
lock using the appropriate ring nut (5).
5) Insert the fan (3) on the motor shaft and lock with the appropriate ring nut (2) turning it tightly
anti-clockwise.
6) Couple the front grid (1) with the rear grid (6) and lock with the plastic ring (4) and ensure the
fastening with the appropriate locking screw, (the screw must be in the lower part). Having done
this, check that the protection grid is firmly coupled and fastened to the motor.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar (Italy).
The pages must be reproduced and folded in order to obtain
a booklet A5 (+/- 148.5 mm width x 210 mm height). When
folding, make sure you keep the good numbering when you
turn the pages of the I/B. Don't change the page numbering.
Keep the language integrity.
8 24
/
Assembly page 8/20
(220-