Bimar VT24A Folleto De Instrucciones página 9

Fax +32 030 9904733

Mod.VT34A-VT44A
Pic.1
ASSEMBLY (mod. VT24A)
Attention: the fan can be used only when completely and correctly assembled, that is complete with
its base and protection grid. If in doubt, have the appliance checked or assembled by a qualified
professional person. For assembly, refer to figure.
Attention: always unplug the appliance before you assemble
1) Pass the cable (20) through the hole in the base and engage the base on the bottom part of the
column, making sure they are correctly positioned one against the other. Fasten the parts using the
screws provided "3" and lock them in a normal way.
2) Fasten the cable to the base using the plastic plate.
3) Insert the handle (23) in the motor casing so the 4 pins enter the corresponding slots. The handle
must be positioned correctly (upwards and towards the back part), otherwise the grid cannot be
fastened.
4) Fasten the rear grid (17) to the motor casing, positioning the corresponding pins and holes, and
lock using the appropriate ring nut (16).
5) Insert the fan (14) on the motor shaft.
6) Couple the front grid (13) with the rear grid (17) and lock with the plastic ring and ensure the
fastening with the appropriate locking screw (15), (the screw must be in the lower part). Having
done this, check that the protection grid is firmly coupled and fastened to the motor.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar (Italy).
The pages must be reproduced and folded in order to obtain
a booklet A5 (+/- 148.5 mm width x 210 mm height). When
folding, make sure you keep the good numbering when you
turn the pages of the I/B. Don't change the page numbering.
Keep the language integrity.
9 24
/
Assembly page 9/20
1. Front grille
2. Fan attachment ring nut
3. Fan
4. Grille attachment ring nut
5. Screw for the plastic ring
6. Rear grille
7. Oscillation button
8. Selector
9. Cord
10. Base
11. Screw of the base
12. Handle