Publicidad
Idiomas disponibles
Idiomas disponibles
B、After finishing washing, confirm the place of the float ball: If the float ball
is on the bottom and the machine is on, this condition is normal, the
program will turn into pressure balance process, the water level will be
controlled automatically; If the float ball is on the upper position and the
machine stops, it means that there are some problems with the water level
sensor, water pump or drain valve.
Point： the water-filter core is consumable, it is not in the guarantee scope. If
you need it, please contact with our marketing department and buy it.
5. Please according to the following steps if you havn't used the machine
for a long time.
A、Turn off the power switch, take out the plug of the machine, then cut off
the power supply and water supply.
B、Take out the ice block from the cabinet, wipe out the water on the inner
of the cabinet.
C、Wipe out the water on the cabinet, and then open the door, make the
cabinet fully dried.
TROUBLE SHOOTING
Fault
Analysis
Solution
The electric wire didn't connect
Check the wire.
well.
Do not
Take out the ice block so
make ice
The retained board was pinned
as to let the retained
by ice block.
board return to the original
situation.
- 16 -
Publicidad
