Publicidad
3.5.5 Pipe connection layout
Heat pump circuit
outdoor unit
3.5.6 Fitting instructions
!
The product must be filled with water before the power is switched on.
Any overflow pipe from the T&P valve must be installed uninterruptable and frost-free
!
with a continuous fall to the drain/gully.
The product should be placed in a room with a drain to avoid any damages in case of
!
water escaping from the product.
The product should be placed on a floor surface suitable for the total weight of the prod-
!
uct when in operation. See product data plate.
!
The product must have a service clearance of 120 cm in front of the cover / 50 cm on top.
3.5.7 Installation recommendation
Allow clearance to the floor for venting purposes. Screw the feet out a minimum of 15 mm
-
from the bottom of the product.
indoor
unit
60 70
50
40
80
30
°C
90
20
100
10
110
0
120
!
WARNING
!
CAUTION
RECOMMENDATION
DHW
Radiator circuit
9
Publicidad
