Wrong Usage Of The Machine; Instructions For Maintenance, Adjustment And Safety Of People - Primus T9-35 Manual De Uso

The machine is not intended for drying the linen containing parts of plastics, glass fibres and foam rubber.
Before starting the drying action, remove any articles from garments, as e.g. nails, pins, screws, etc. which
could damage the garments as well as the machine. Linen must be rinsed and spin-dried properly. Recommended
residual moisture of linen before drying should be 50% - 70% to get an optimal result.
For the machine correct function it is necessary to clean the lint filter once a day at least. Stop the machine
before you clean the filter. Remove cover of lower panel. For double dryer 13/13kg open both filter covers.
Remove the lint filter and clean it. At the same time clean area in front of the lint filter. Pieces of lint on this area
would pollute the lint filter and reduce effectiveness of drying process. Put the filter back and close the cover.
Always finish the drying cycle by cooling down the linen. Remove the linen immediately after finishing the drying
cycle.

2.3. WRONG USAGE OF THE MACHINE

WARNING !
!
THIS MACHINE IS DESIGNED FOR INDUSTRIAL DRYING OF LINEN. IT IS NOT INTENDED FOR HOUSEHOLD
USE. ANY USAGE DIFFERENT THAN MENTIONED ABOVE, WITHOUT WRITTEN AGREEMENT
OF THE SUPPLIER, WILL BE CONSIDERED AS IMPROPER USAGE.
– Do not load the machine with bigger amount of linen than it is designed for.
– Do not forget to clean the lint filter regularly.
– Do not stop the machine until the drying cycle including cooling down is finished, except of emergency events.
– Do not dry synthetic fabrics at high temperature.
– Do not leave the linen in the machine after the drying cycle is finished.
2.4. INSTRUCTIONS FOR MAINTENANCE, ADJUSTMENT AND SAFETY
OF PEOPLE
The following information are not mentioned in this „User´s manual". You can find missing information in
„Installation and maintenance manual", which is delivered with the machine.
References to „Installation and maintenance manual" according to norm EN ISO 10472-1(-4):
1. Information about providing the user´s manual
2. Extent of the machine usage and limits
3. Maintenance and adjustment
4. Ventilation
5. Covers
6. Defects, cleaning, maintenance
7. Thermal risks
8. Exhaust system
9. Handling, installation
8 USER´S MANUAL PUBLICATION DATE 08/05 508 992