Descargar Imprimir esta página

SUHNER TURBO TRIM II SHS 945 Documentación Técnica página 29

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 38
Loose the screw and remove the lever.
Unscrew the pipe of the flexible shaft and decompose
it into parts. The coupling is provided with a left hand
thread. Clean the parts thoroughly with a brush and de-
tergent. Rinse with water and let it dry. Do not use ag-
gressive detergent! To connect the hand pieces, follow
the above instructions in reverse order. After connecting,
press the grease cup button two to three times.
4.1.2 r
egrinding the BlAde
The blade can be reground with a com-
mercially available grinding machine.
There are special adapter plates available
for SUHNER blades.
V
ery shArp BlAde
4.1.3 h
Ardening the BlAde
resentative or directly from the manufacturer. Apply the
steel under a light pressure. The last pass should be
along the inside of the blade. When cutting does not im-
prove, the blade must be replaced. Contact the area rep-
resentative or the manufacturer for further information.
O
utside edge
Make sure that the steel is held flat and over the blade's
centre line.
!
Exclusively SUHNER steel
must be used. This can be
purchased from the area rep-
i
nside edge
The inside edge is hardened at the press of the button
when the machine is running. At the same time the hand
piece must be held downwards or away from the user.
V
ery shArp BlAde
4.1.4 h
Oning the BlAde
Before honing, clean the hand
piece of all fat and meat residue.
The blade must be honed every day with a knife sharp-
ener or a stone.
With the motor running, hold the flat side of the whetstone
against the flat side of the blade. Move the whetstone
back and forth.
!
29

Publicidad

loading

Este manual también es adecuado para:

Turbo trim ii shs 945 wave