Publicidad
Idiomas disponibles
Idiomas disponibles
the hot water position and the water will flow out.
• When the power cord is damaged, call a qualified
technician and replace with the power cord supplied by the
factory.
• The outlet must be properly grounded, and it is prohibited
to use tap water as an earthing. To avoid electric shock,
the ground wire must not be electrified. Note that the
water heater can not be connected in any case to a plug
where the current will be less than necessary.
• Cold water inlet must be installed with the provided one-
way safety valve. The drain pipe connected to the safety
valve must be connected with air. The drain pipe and
safety valve must be installed in a frost-free environment
to prevent freezing.
• The safety valve should be checked regularly. To do this,
unscrew the safety screw by turning in the transverse
direction and check that water flows out of the drain pipe.
If the thermostat works properly, the water will come out
regularly. Otherwise contact the technical service of the
product.
• If the tap water pressure is greater than 0.8Mpa, the water
will come out of the safety valve. In that case, install an
additional valve on the water supply line, but install it away
from the heater. For example, at the place where the water
supplies enters.
• When the unit is turned on, there might be water drops
coming out from the one-way safety valve, which is a
normal phenomenon. Do not block it. Otherwise, accident
may occur.
Publicidad
