Publicidad
Idiomas disponibles
Idiomas disponibles
EN
ERGOFRESH MIG WELDING TORCH
DECLARATION OF CONFORMITY
Trafimet Group Spa, a duly registered Italian Manufacturing Company, located in Via del Lavoro, 8 36020 Castegnero (VI),
EN 60974-7
hereby declares that products identified and described in this manual are in conformity with the provisions of Low Voltage
Directive 2014/35 EU and in compliance with the standards set by EN 60974-7 Arc Welding Equipment - Part 7.
ISO 21904-1
ISO 21904-3
Trafimet Group Spa, a duly registered Italian Manufacturing Company, located in Via del Lavoro, 8 36020 Castegnero (VI),
hereby declares that the products identified and described in this manual comply with the provisions of the Electrical
Equipment (Safety) Regulations 2016 and the Restriction of the Use of Certain Hazardous Substances in Electrical and
Electronic Equipment Regulations 2012.
IMPORTANT NOTES
Read the instructions through carefully. For your own safety, and that of your working environment, pay particular attention to the
safety instructions delivered with the equipment.
Dispose of this product responsibly after use. Torches and used parts should be properly recycled according to the local
requirements and regulations.
Disconnect the power source from the mains power supply before handling electrical cables or performing torch maintenance.
Before connecting the torch, switch off the power source, disconnect the power plug and turn off the gas supply.
Always use the original Trafimet spare parts and consumables.
Items in the manual that require particular attention in order to minimize damage and harm are indicated with the below symbols. Read
these sections carefully and follow their instructions.
Note: Gives a useful piece of information.
Caution: Describes a situation that may result in damage to the equipment or system.
Warning: Describes a potentially dangerous situation. If not avoided, it will result in personal damage or fatal injury.
ABOUT EQUIPMENT
ERGOFRESH manual MIG/MAG welding torches are designed for welding low- and high-alloyed materials. ERGOFRESH welding torches
capture welding fumes at the arc, cleaning the welder's breathing zone. ERGOFRESH range covers both water-cooled and gas-cooled
models for MIG welding. Fume extraction torches are used in conjunction with a fume extraction unit. ERGOFRESH welding torches are
compatible with fume extraction units of most major manufacturers. For more information, refer to the fume extraction unit manufacturer's
documentation.
The equipment consists of (the exact visual details may differ between different torch models):
1) Gas diffuser
2) Contact tip holder
3) Contact tip
4) Vacuum nozzle
5) Gas nozzle
2
All trademarks are the property of their respective owners. The information and images are indicative and may be subject to change at any time without notice.
1
2
3
4
2
3
1
4
© 2023 Trafimet Group SpA
200G/350G/300W
5
500W/555W
5
Publicidad
