OWNER'S MANUAL | USING YOUR BLACKSTONE
lPG CYlINdeR ReQUIReMeNTS
FOR 20 LB (9 KG CYLINDERS)
• The lPG supply cylinder to be used must be constructed and
marked in accordance with the specifications for lP gas cylin-
ders, U�S� department of Transportation (doT) or the Standard for
Cylinders, Spheres and Tubes for the Transportation of dangerous
Goods, CAN/CSA-B339�
• only lPG cylinders marked "propane" shall be used�
• The lPG cylinder supply system must be arranged for vapor
withdrawal�
• • Always keep new lPG cylinders in upright position during use, transit or
Always keep new lPG cylinders in upright position during use, transit or
storage.
storage.
• • Always keep the ventilation opening(s) of the cylinder enclosure free and
Always keep the ventilation opening(s) of the cylinder enclosure free and
clear from debris.
clear from debris.
THE LPG CYLINDER VALVE MUST HAVE:
• Type 1 valve outlet (thread on the outside)�
• Safety relief valve�
• Ul listed overfill Protection device (oPd)� This oPd safety feature is
identified by a unique triangular hand wheel�
• dust cap�
lPG cylinder valve
lPG cylinder valve
Safety relief
Safety relief
valve
valve
dust cap
dust cap
The seal on the type 1 valve outlet could, over time, show marked and
visible damage or deterioration that might cause a leak even with
the connection tightened�
• A visual inspection for the seal must be carried out every time a
lPG cylinder is replace or refilled�
• Any lPG cylinder showing signs of damage or deterioration as
those illustrated including visible cracks and pitting, must be
returned unused to the seller�
STORING LPG CYLINDERS
• DO NOT store a spare LPG cylinder under, near, or in this
appliance.
• DO NOT fill an LPG cylinder beyond 80% full.
If the information above is not followed exactly, a fire causing
death or serious injury may occur.
• The lPG cylinder must be turned oFF when the appliance is
not in use�
• lPG cylinders must be stored outdoors and out of the reach
of children�
• do NoT store an lPG cylinder inside a building, garage, or any other
enclosed area�
10
oPd hand wheel
oPd hand wheel
Type 1 valve outlet
Type 1 valve outlet
(check seal before use)
(check seal before use)
GOOD SEAL
GOOD SEAL
BAD SEAL
BAD SEAL
WARNING
FILLING & ExCHANGE
• Use only those reputable exchange companies that inspect, preci-
sion fill, test and certify their cylinders� lPG dealer must purge new
cylinder before filling�
• Volume of propane in cylinder will vary by temperature�
A frosty regulator indicates gas overfill.
Immediately close LPG cylinder valve and call local LPG
dealer for assistance.
• do NoT release liquid petroleum gas (lPG) into the atmosphere�
• To remove gas from lPG cylinder, contact a certified lPG dealer or
local fire department for assistance�
• exchange cylinder only for an oPd safety feature-equipped
cylinder�
Your retailer can help you match a replacement lPG cylinder to your appliance.
Your retailer can help you match a replacement lPG cylinder to your appliance.
LEAK TEST INSTRUCTIONS
• leak test new and exchanged lPG cylinders BeFoRe connecting
to griddle�
• do NoT smoke during leak test�
• do NoT use an open flame to check for gas leaks�
• Appliance must be leak tested outdoors in a well-ventilated
area, away from ignition sources such as gas fired or electrical
appliances�
• during leak test, keep appliance away from open flames or sparks�
LEAK TEST: LPG CYLINDER
Use a clean paintbrush
STEP 01
to brush a 10�90 mild soap and
water solution onto joint areas of
the lPG cylinder�
(Indicated by arrows in figure 01.)
(Indicated by arrows in figure 01.)
• leaks are indicated by
growing bubbles�
WARNING
If growing bubbles appear
during leak test, DO NOT use
or move the LPG cylinder.
Immediately contact an LPG
supplier or fire department.
FITTINGS & HOSES
• Annual checking and tightening of metal fittings is recommended�
• Keep the fuel supply hose away from any heated surfaces�
• Before each use, check to see if hoses are cut or worn�
• Replace damaged hose before using appliance�
(Use only Blackstone approved valve, hose, or regulator. Failure to comply will
(Use only Blackstone approved valve, hose, or regulator. Failure to comply will
void the warranty.)
void the warranty.)
Model: 1517AZ
WARNING
figure 01
figure 01
BLACKSTONEPRODUCTS.COM/SUPPORT