Publicidad
Idiomas disponibles
Idiomas disponibles
■
Always remove the battery during work
breaks, when servicing the appliance and
when it is no longer in use. The appliance must
be kept clean, dry and free of oil and grease at
all times.
■
Remain alert at all times! Always pay attention
to what you are doing and act with common
sense. Do not use the appliance if you are
distracted or feeling unwell.
WARNING!
Always wear safety goggles.
WARNING!
Always wear a dust mask!
Before use
Charging the battery pack (see fig. A)
CAUTION!
►
Always unplug the appliance before you
remove the battery pack
the battery pack to the charger.
■
Never charge the battery pack
ambient temperature is below 10°C or above
40°C.
♦
Connect the battery pack
battery charger
♦
Insert the power plug into the socket.
The control LED
♦
The green charge control LED
the charging process is complete and the bat-
tery pack
is ready.
ATTENTION!
♦
If the red charge control LED
means that the battery pack
ed and cannot be charged.
♦
If the red and green charge control LEDs
both flash, this means that the battery
pack
is defective.
♦
Switch off the charger for at least 15 minutes
between successive charging sessions. Also
disconnect the power plug from the mains
power socket.
│
GB │ IE
■
30
from or connect
when the
to the high-speed
(see fig. A).
lights up red.
indicates that
flashes, this
has overheat-
Attaching/disconnecting the battery
pack to/from the appliance
Attaching the battery pack:
♦
Push the battery pack
clicks into place.
Removing the battery pack:
♦
Press the release button
battery pack
.
Checking the battery charge level
♦
Press the battery charge level button
check the status of the battery (see also main
diagram).
The status/remaining charge will be shown on
the battery display LED
♦
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
Fitting the blade guard with quick
release
WARNING! RISK OF INJURY
►
Always switch the appliance off and remove
the battery before carrying out any work on
the appliance.
RISK OF INJURY
►
Always use the angle grinder with the blade
guard
. The blade guard should be fitted
securely. Set this so that the highest possible
degree of safety is achieved, i.e. the smallest
possible part of the grinding disc is open to
the operator. The blade guard
to protect the operator from fragments and
accidental contact with the grinding tool.
into the handle until it
and remove the
to
as follows:
is designed
PWSA 20-Li B2
Publicidad
