Publicidad
Idiomas disponibles
Idiomas disponibles
♦
Lock the mounting spindle
♦
Tighten the clamping nut
rection using the two-hole mounting spanner
NOTE
►
If the disc does not turn smoothly or vibrates
after the change, the disc must be replaced
immediately.
♦
For safety's sake, run the appliance at maximum
speed for 60 seconds after every disc change.
Be aware of unusual noises and sparks.
♦
Check whether all the fastening elements are
correctly fitted.
♦
Make sure that the arrow showing the direction
of rotation (if any) on the cutting or rough grind-
ing discs (including diamond cutting discs) and
the direction of rotation of the appliance (arrow
showing the direction of rotation on the head)
match.
Operation
Switching on and off
Check the inserted tool to ensure that all mounting
parts are correctly attached before use.
NOTE
►
Always switch on the angle grinder before
making contact with the material, then apply
it to the workpiece.
Switching on:
♦
First press the ON/OFF switch
that you can then press it forwards.
Switching off:
♦
Let go of the ON/OFF switch
Switching to continuous operation:
♦
First press the ON/OFF switch
that you can then press it forwards. Then press
the ON/OFF switch
until it engages.
│
GB │ IE
■
32
.
in a clockwise di-
to the right so
.
to the right so
forwards and down
Switching off continuous operation:
♦
Press the ON/OFF switch
downwards and release it.
.
Adjusting the rotational speed
You can use the adjusting wheel for speed prese-
lection
to preselect the rotational speed:
(1 = slower speed, 6 = faster speed).
We recommend you carry out practice tests to
determine the correct speed.
The speed can also be changed during operation.
Maintenance and cleaning
WARNING! RISK OF INJURY!
Always switch the appliance off and
remove the battery before carrying
out any work on the appliance.
The battery angle grinder is maintenance-free.
■
Do not use any sharp objects for cleaning
the appliance. Never allow any liquids to
penetrate inside the appliance. Otherwise the
appliance could be damaged.
■
Clean the appliance regularly, preferably im-
mediately after completion of the work.
■
Clean the housing with a dry cloth – do NOT
use petrol, solvents or cleaners which can attack
the plastic.
■
A vacuum cleaner is required for thorough
cleaning of the appliance.
■
Ventilation openings must never be obstructed.
■
Remove any sanding dust stuck to the appliance
with a brush.
NOTE
►
Replacement parts not listed (such as carbon
brushes, switch) can be ordered via our
service hotline.
to the rear and
PWSA 20-Li B2
Publicidad
