Publicidad
Idiomas disponibles
Idiomas disponibles
.
.
Place accessory tray (A) over holes (B) on handle
(viewing from front of unit). Push the tree clips
(C) into the holes until they sit flat against the
accessory tray.
/
Place bottle brackets (D) facing outside over holes
in handle supports. Secure bottle brackets with
carriage bolts (E) and plastic knobs (F). Tighten by
hand.
Attach
Project
Pro@ Perfect
Mix
TM
Siphon
1.
Attach the tube end of the blue Perfect Mix Siphon
(G) to the barbed tube fitting (H) on the pump.
Add Engine
Oil
1.
Place pressure washer on a flat, level surface.
2.
Clean area around oil fill and remove yellow oil fill
cap/dipstick.
3.
Hold neck of supplied oil pouch and remove cap.
4.
Slowly pour contents of oil pouch into oil fill
opening. Checking oil level frequently, fill to FULL
mark (top hole) on dipstick.
Full
NOTICE
Pause to permit oil to settle. Wipe dipstick
clean each time oil level is checked. DO NOT overfill.
NOTICE
Improper treatment of pressure washer
could damage it and shorten its life.
o DO NOT attempt to crank or start the engine before it has
been properly serviced with the recommended oil. This
could result inan engine failure.
5.
Replace oil fill cap/dipstick and fully tighten.
Add Fuel
Fuel must meet these requirements:
o Clean, fresh, unleaded gasoline.
2.
Place Perfect Mix bottles (not included) in the
bottle brackets on the handle.
3.
Remove cap from one of the bottles and insert the
PerfectMix Siphon (J). Screw the siphon unit to the
top of the bottle (K).
NOTICE
Use the clip on the cap to snap siphon to
wire form bracket when siphon is not in a concentrate
bottle.
A minimum of 87 octane/87 AKI (91 RON). For
high altitude use, see Hfigh A/titude.
Gasoline with up to 10% ethanol (gasohol) is
acceptable.
NOTICE
Use of unapproved
fuels could damage
generator
and voids warranty.
DO NOT use unapproved gasoline such as E15 and E85.
DO NOT mix oil in gasoline or modify engine to run on
alternate fuels.
WARNmNG
Fuel and its vapors are extremely
flammable
and explosive
which could
cause burns, fire or explosion
resulting in death or serious injury.
WHEN ADDING FUEL
, Turn pressure washer engine OFF and let it cool at least
2 minutes before removing fuel cap. Loosen cap slowly to
relieve pressure in tank.
Fill fuel tank outdoors.
DO NOT overfill tank. Allow space for fuel expansion.
If fuel spills, wait until it evaporates before starting engine.
Keep fuel away from sparks, open flames, pilot lights,
heat, and other ignition sources.
Check fuel lines, tank, cap and fittings frequently for
cracks or leaks. Replace if necessary.
DO NOT light a cigarette or smoke.
Publicidad
