Care And Maintenance - Beurer EM 44 Manual De Instrucciones

Setting the Custom Function
• Select your program and the corresponding settings as described in chapter 7.
• At the start of treatment, the impulse intensity is set to 00 by default. No impulses are sent to the electrodes yet. Before setting the
desired impulse intensity using the intensity setting buttons, press and hold the `CH2-´ button for 5 seconds. Storage in the
Custom Function is confirmed by a long beep.
If you switch on the device again, the program you saved using the Custom Function is recalled.
Deleting the Custom Function
To clear the device and gain access to other programs again, press and hold the`CH2-´ button again for approx. 5 seconds. To do this,
the impulse intensity must be set to 00. Deletion of the Custom Function is confirmed with a long beep.

11. Care and Maintenance

Adhesive Electrodes:
1. To ensure that the adhesive on the electrodes lasts as long as possible, run the adhesive side under lukewarm water and pat dry with a
lint-free cloth. Before cleaning with water, remove the connection cables from the electrodes.
2. Reapply the electrodes to the carrier foil after treatment.
Main Unit:
1. Remove the batteries from the device before cleaning.
2. Clean the device after use with a soft, slightly damp cloth. You can also moisten the cloth with a mild detergent solution. Ensure that no
water enters the device.
3. Do not use any chemical or abrasive cleaning agents.
Storage:
1. Remove the batteries from the device if you will not be using it for a prolonged period of time.
2. Do not make sharp bends in the connection cables and electrodes.
3. Disconnect the connection cables from the electrodes.
4. Reapply the electrodes to the carrier foil after use.
5. Store the device and accessories in a cool, well-ventilated space. Never place any heavy objects on the device.
18