Sharp RT-350H Manual De Manejo página 7

CONNECTING TO AN AMPLIFIER
® (f the AC supply lead plug is already connected to the AC outlet, © ® Donotconnect the deck to other decks by using a straight DIN type
check that the POWER switches of both the RT-350H and amplifier lead.
are inthe cy STAND-BY or OFF position before connecting the Areversed, attenuated DIN lead may be necessary for this purpose
units with audio cables, but such use is not recommended.
NOTE FOR UNITS EQUIPPED WITH A NON-POLAR AC
SUPPLY PLUG:
If a humming noise occurs, unplug the AC supply plug from the AC
outlet and reverse the polarity (i.e., unplug and turn the plug over),
and use in the position that gives the least noise.
To REC/PB socket
To AC outlet
Connect the DIN connector lead between the
REC/PB socket on the RT-350H and the REC/
PB socket on the amplifier.
Connect the other set of cables between the
LINE IN sockets on the RT-350H and the
output (TAPE REC, TAPE OUT, etc.) sockets on
the amplifier.
To TAPE REC or
TAPE OUT sockets
Amplifier
= ->
To AC outlet
To TAPE PB or
TAPE IN sockets
To LINE OUT sockets
Connect one set of cables between the LINE
OUT sockets on the RT-350H and the input
{TAPE PB, TAPE IN, etc.} sockets on the
amplifier.
[E] 5