Descargar Imprimir esta página

Electrolux LYB1AF8W0 Manual De Instrucciones página 15

Ocultar thumbs Ver también para LYB1AF8W0:

Publicidad

Idiomas disponibles

Idiomas disponibles

Problem
Water flows inside the re‐
frigerator.
Water flows on the floor.
The temperature in the ap‐
pliance is too low/too high.
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.
Possible cause
Food products are not
wrapped properly.
Temperature is set incor‐
rectly.
Appliance is fully loaded
and is set to the lowest
temperature.
Temperature set in the ap‐
pliance is too low and the
ambient temperature is too
high.
Food products prevent the
water from flowing into the
water collector.
The water outlet is clog‐
ged.
The melting water outlet is
not connected to the evap‐
orative tray above the com‐
pressor.
The temperature is not set
correctly.
The door is not closed cor‐
rectly.
The food products' temper‐
ature is too high.
Many food products are
stored at the same time.
The thickness of the frost
is greater than 4-5 mm.
The door has been opened
often.
There is no cold air circula‐
tion in the appliance.
8.2 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to "Installation" chapter.
ENGLISH
Solution
Wrap the food products
better.
Refer to "Operation" chap‐
ter.
Set a higher temperature.
Refer to "Operation" chap‐
ter.
Set a higher temperature.
Refer to "Operation" chap‐
ter.
Make sure that food prod‐
ucts do not touch the rear
plate.
Clean the water outlet.
Attach the melting water
outlet to the evaporative
tray.
Set a higher/lower temper‐
ature.
Refer to "Closing the door"
section.
Let the food products tem‐
perature decrease to room
temperature before stor‐
age.
Store less food products at
the same time.
Defrost the appliance.
Open the door only if nec‐
essary.
Make sure that there is
cold air circulation in the
appliance. Refer to "Hints
and Tips" chapter.
15

Publicidad

loading