Publicidad
Idiomas disponibles
Idiomas disponibles
STROBE Mode
It should be worked with Auto/sound/fade/manual/0-9 modes together.
Press STROBE one time, it is 1/8 speed, second time to 2/8 speed, press eighth time to 100% speed.
SENSITIVITY Mode
It is a reset function. Press it one time, enter the function, press it again and the device will restore
factory setting, exiting the remote control and entering A001 mode (6 DMX channels).
SPEED Mode
No function
WIRELESS DMX CONTROL
Setup wireless DMX
The fixture needs to be paired with a wireless DMX transmitter. We advice to use MARK ® UNIVERSAL
CONTROLLER. Follow below steps to pair.
1. Connect the DMX controller to the DMX transmitter (UNIVERSAL CONTROLLER).
2. Switch on the MBAR BAT 144 WI and select "rfon" in the menu and press enter
3. Select the DMX mode (Axxx or dxxx)
4. Switch off the device. Press and hold "DMX select" button whilst switch on the fixture. The unit
passes to wireless status and the LED will be lit in white colour.
5. The colour of the LED will change according to the protocol used for the transmission as shown
on table 1. Pressing the button will cycle through the colours and once you want to set the
protocol pressing the button for more that 1s , in order to save the protocol. Both devices,
transmitter and fixture will remember the protocol used in the future.
TABLE 1
COLOUR
PROTOCOL
RED
ELDMX Transmitt and receive
GREEN
W-DMX Receive
BLUE
W-DMX G3 Transmitt
YELLOW
W-DMX G4 Transmitt
PURPLE
GZ Receive (Receiver only)
9
Publicidad
