Publicidad
Idiomas disponibles
Idiomas disponibles
Solid colour (red, green,
blue, yellow, cyan,
magenta, white)
ELDMX/GZ
Flashing Red
Flashing Green
CAUTIONS
Prevention of electric shock
The electrical connection must only be carried out by qualified personal. Before installing, make sure
you use the same power voltage marked in the MBAR BAT 144 WI (90-240V/50-60Hz). Each device
must be properly grounded and installed in accordance with the relevant standards. Don't use the
device in a lightning storm or wet environment.
To prevent burning of fire
1. Never install the device directly on the surface of ordinary combustible material.
2. The equipment must be installed away from inflammable and explosive materials.
3. Keep at last 0,5 m around the unit to ventilation purpose.
4. Do not place any object on the lens.
5. Do not replace with non-original spare parts. Contact your MARK dealer.
Unpacking Note: Before unpacking, check it for possible damage that might have occurred during
transportation or not. If you find any damage, please do not use the unit and contact the MARK dealer.
TROUBLESHOOTING
This short guide is meant to help and try to solve simple problems. If they continue and the device
cannot operate, please, don't try to repair it by yourself, return the device to your MARK dealer.
If a problem occurs, carry out the following steps in sequence until find the problem solved. If the light
effect does not operate properly, refer servicing to a technician.
1 of the 7 colour groups. White colour only in GZ mode
Transmitting DMX
Receiving DMX
11
Publicidad
