Publicidad
Idiomas disponibles
Idiomas disponibles
4. Press ENTER
button to accept selection and exit to Mode Setup menu.
EXIT
THEN DISABLED
Note: Menu selection indicates current configuration (ENABLED or DISABLED).
Torque THEN Angle Mode
Torque THEN Angle mode is setup by first setting a target torque and units then a target angle before
selecting Torque THEN Angle mode. In Torque THEN Angle mode, when applied torque reaches target
torque, wrench automatically switches to angle mode for angle measurement. Progress lights indicate
applied torque progress while torque is measured and angle when angle is measured.
1. From target torque screen, use UP
to select torque measurement units then press ENTER
2. Angle target screen is displayed. Use UP
ENTER
button.
3. Torque THEN Angle mode screen is displayed.
4. Apply torque until target is reached then rotate wrench to target angle.
00
100.0
FT-LB
UP/DOWN buttons
Note: UNITS
U
button can be used to select torque units while on Torque THEN Angle screen.
Note: Torque THEN Angle Presets are entered by pressing and holding Units button while on Torque
THEN Angle screen. Refer to "Adding a Torque Preset" and "Adding an Angle Preset" in Basic
section for parameter entry.
Note: Torque cycle is not recorded in memory unless both torque and angle reach targets.
Note: Red and yellow progress lights turn on if torque exceeds 110% of wrench full scale or if angle
exceeds target plus 4% in manual mode.
Note: Red and yellow progress lights turn on if torque exceeds maximum torque or if angle exceeds
maximum angle in Preset mode.
Delete All Presets
Delete Presets function allows user to delete all presets at once.
1. From Configure menu, use UP
press ENTER
button.
2. Delete Presets confirmation screen is displayed.
3. Use UP
/DOWN
4. Press ENTER
button to accept selection and exit to Configure menu.
TQ THEN ANGLE
ENTER
button
ENABLE
DISABLE
UP/DOWN buttons
TQ THEN ANGLE
ENABLE
DISABLE
/DOWN
00
ENTER
button
45°
UP/DOWN buttons
/DOWN
buttons to select YES or NO selection.
ENTER
EXIT
button
THEN DISABLED
ENTER
EXIT
button
THEN ENABLED
buttons to set target torque and UNITS
button.
/DOWN
buttons to set target angle then press
ENTER
button
TQ: 100.0 FT-LB
THEN AN: 45°
Torque THEN Angle Screen
buttons to highlight
18
00
DELETE PRESETS
U
button
selection then
Publicidad
