Publicidad
Idiomas disponibles
Idiomas disponibles
EXIT
MODE SETUPs
DELETE PRESETS
CALIBRATION
UP/DOWN buttons
EXIT
MODE SETUP
DELETE PRESETS
CALIBRATION
Note: If Delete Presets is selected without a Preset configured, following screen is displayed:
Calibration
Calibration menu is password protected. Contact your local Snap-on Repair
Center regarding Calibration menu.
Setting Date and Time
Set Date/Time function allows user to set real-time-clock date and time for time stamping data
records, recording last calibration date and notifying user of an expired calibration interval.
Note: When date and time is set for first time, In-Service date is also set and is used for calculating
initial calibration interval (see "Setting Calibration Interval" in Advanced Configuration section).
1. From Configure menu, use UP
press ENTER
button.
2. SET DATE screen is displayed with year highlighted.
3. Use UP
/DOWN
4. Use UP
/DOWN
5. Use UP
/DOWN
6. SET TIME screen is displayed with Hour highlighted.
7. Use UP
/DOWN
8. Use UP
/DOWN
9. Use UP
/DOWN
10. Clock is set and Configure menu is displayed.
MODE SETUP
DELETE PRESETS
CALIBRATION
SET DATE/TIME
ENTER button
Delete Presets menu
DELETE PRESETS
ENTER
button
YES
NO
UP/DOWN buttons
NO PRESETS
PRESS
TO CONT.
/DOWN
buttons to set year then press ENTER
buttons to set month then press ENTER
buttons to set day then press ENTER
buttons to set hour then press ENTER
buttons to set minutes then press ENTER
buttons to set seconds then press ENTER
ENTER
button
SET DATE
2019/01/01
YR MON DAY
UP/DOWN buttons
SET TIME
12
: 00 : 00
HR MIN SEC
UP/DOWN buttons
buttons to highlight
ENTER
button
SET DATE
2019/01/01
YR MON DAY
UP/DOWN buttons
ENTER button
ENTER
button
SET TIME
12 :
00
: 00
HR MIN SEC
UP/DOWN buttons
19
EXIT
MODE SETUP
DELETE PRESETS
CALIBRATION
SET DATE/TIME
button to highlight month.
button to highlight day.
button.
button to highlight minutes.
button to highlight seconds.
button.
ENTER
button
SET DATE
2019/01/01
YR MON DAY
UP/DOWN buttons
ENTER
button
SET TIME
12 : 00 :
00
HR MIN SEC
UP/DOWN buttons
selection then
Publicidad
