Publicidad
Idiomas disponibles
Idiomas disponibles
IMPORTANT SAFETY INSTRUCTIONS
WARNING
Over-torquing can cause breakage. Force against flex stops on flex head can cause
head breakage. An out of calibration angle wrench can cause part or tool
breakage. Broken hand tools, sockets or accessories can cause injury. Excess force
can cause crowfoot or flare nut wrench slippage.
Read this manual completely before using ELECTRONIC WRENCH.
To ensure accuracy, work must not move in angle mode.
For personal safety, and to avoid wrench damage, follow good professional
tool and fastener installation practices.
Periodic recalibration is necessary to maintain accuracy.
Wear safety goggles, user and bystanders.
Be sure all components, including all adaptors, extensions, drivers and sockets
are rated to match or exceed torque being applied.
Observe all equipment, system and manufacturer's warnings, cautions and
procedures when using this wrench.
Use correct size socket for fastener.
Do not use sockets showing wear or cracks.
Replace fasteners with rounded corners.
To avoid damaging wrench: Never use wrench with power off. Always turn ON
wrench so applied torque is being measured.
Do not press POWER
Never use this wrench to break fasteners loose.
Do not use extensions, such as a pipe, on handle of wrench.
Check that wrench capacity matches or exceeds each application before
proceeding.
Verify calibration if dropped.
Make sure ratchet direction lever is fully engaged in correct position.
Verify calibration of wrench if you know or suspect its capacity has been
exceeded.
Do not force head of flex head drives against stops.
Always pull - do not push - on wrench handle and adjust your stance to
prevent a possible fall should something give.
Do not attempt to recharge alkaline cells.
Store wrench in dry place.
Remove batteries when storing wrench for periods longer than 3 months.
WARNING
Electrical shock can cause injury. Plastic handle is not insulated.
Do not use on live electrical circuits.
SAVE THESE INSTRUCTIONS
Disclaimer
Operation of TechAngle
instructions are not in that State's language. Contact Snap-on if a translation is
needed.
of flying particles.
Risk
while torque is applied or while wrench is in motion.
Electrical Shock Hazard.
®
Wrench is not warranted in an EU member state if operating
1
Publicidad
