Publicidad
Idiomas disponibles
Idiomas disponibles
How
to
remove
the
built-in
rechargeable
battery
before
disposal of the shaver (see fig. 9)
The procedure described in fig. 9 is
intended only for removal of proper
disposal. Discard shaver after the
battery has been removed.
WARNING: Do not attempt to re-
place the batteries for the pur-
pose of reusing the shaver. This
could result in the risk of fire or
electric shock.
1. Remove the protective cap, outer
foil frame and inner blade.
2. Remove the two screws (a) on the
top.
3. Remove the two screws (b) and
remove the bottom cover (c).
4. Push the chassis (d) out of the
housing.
5. Remove the battery (e) frorn the
chassis.
Caution
Do not charge the shaver where the
temperature is below 0°C (32°F) or
above 40°C (104°F), where it will be
exposed to direct sunlight or a heat
source, or where there is a lot of
moisture.
Use only the included shaver charg-
ing adaptor RE3-40 to charge the
ES364 shaver.
Dry the shaver completely before
setting it in the charging adaptor.
Keep the charging adaptor away from
water and handle it only with dry
hands. Do not use an extension cord
to connect the charging adaptor to
an outlet.
Store the charging adaptor in a dry
area where it will be protected from
damage.
The outer foi! is very thin. If handled
improperly, it can be easily damaged.
To avoid personal injury, do not use
the shaver if it has a damaged foil or
inner blade.
Wash the shaver in tap water. Do not
use salt water, detergent or boiling
water. Do not submerge the shaver
for a long time.
Do not wipe it with thinner, benzine
or alcohol. Clean it by cloth with
soapy water.
Do not take the housing apart as thís
can affect the watertight construction.
Specifications
Power source: 100-120V AC,
50-60 Hz
Motor voltage: 1.2 V DC
Charging time: 8 Hours
Household Use
READ ALL INSTRUCTIONS
BE-
FORE USE.
FOR YOUR CONVENIENCE, WE HAVE ESTABLISHED A TOLL-FREE
NATIONAL ACCESSORY uiis
a HOT LINE AT 1-800-338-0552.
Publicidad
