Panasonic CX-DP88U Manual De Instrucciones página 18

Installation Guide continued
O Electrical Connection
e This system is be used only in a 12-volt DC battery system (car) with negative ground.
e Follow the wiring connection diagram. Failure to do so may result in damage to the unit.
e First, connect the extension cord @ to the CD changer and then, connect the RCA pin connectors and
the extension cord 8p DIN connector to the CD/cassette receiver. Finally, connect the battery lead (yel-
low) to a constant power supply.
e Please carefully read the operating and installation instructions of the respective equipment before con-
necting it to this unit.
In combination with the cassette receiver (CQ-FX620U)
Wiring Accessory
O A
Extension Cord (DIN/BATT/RCA/GND)
CD Changer
CX-DP88U
@Extension Cord Xx G round Lead
(DIN/BAT T/RCA/GND) To a clean, bare metallic
part of the car chassis
Fuse (34) Battery Lead
To the car battery,
continuous +12V DC
Be sure to connect to a well grounded metallic
part of your car because noises or troubles
may occur.
a DIN Cord
RCA Cord (L) Hi
RCA Cord (R)
Cassette Receiver
CQ-FX620U Changer
Control Connector
Ántenna
18