Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING THE HEAD VIA THE INTERFACE PANEL
LED strips
control keys
White stripes
5 stripes
26°C
4 strips
24°C
3 strips
21°C
2 strips
18°C
1 strip
15°C
Red stripe
In the appendix, the temperature of
28°C is enabled.
1. To wake up the device from the sleep mode, briefly press any button.
2. To raise or lower the temperature by one step, briefly press + or − button.
3. To swap the + and −, buttons, press and hold (> 10 s) the + button.
Red stripe
EN
4. Modes and special actions — press and hold both + and − buttons
simultaneously:
a. for 10 s — the heating element will be put to sleep (stand-by mode)
(single flash on the interface);
b. for 15 s — enter pairing mode (AP) all interface will flash 3 times;
c. for 25 s — restore factory settings and start the pairing mode, the de-
vice will flash as it did at set-up;
5. If the head controller panel has been blocked (the PARENTAL CON-
TROL function in the control application), pressing the + key for 5 sec-
onds will release the lock for 1 minute, which will allow you to change
the settings manually on the device without the need to use the appli-
cation (confirmation by flashing interface).
The change made on the device manually is valid until the next automatic
temperature change saved in the schedule.
7
Publicidad
